- Never miss a raindrop with the Garland Water Butt Linking Kit
- This clever little kit allows you to link two water butts together to provide double the water storage capacity from your downpipe
What you need to know:
- 1 x Garland Water Butt Linking Kit
- Kit includes: 1 x 500mm Connector Hose, 2 x 20mm Connectors, 2 x Washers, 2 x Nuts
- The water butts to be connected should be on a level surface and no more than 39cm apart. The water butts can be connected at the bottom, then the two water butts will fill at the same rate. If connected at the top the first butt will fill then run over into the second
- BEWARE Do not use an electric drill if the Butt contains water
Instructions for use:
- Before drilling make sure both butts are facing each other with the taps at the front
- Drill a 25mm hole approx. 25cm from the top or the bottom into opposite sides of the water butts to be connected
- Join the water butts together with the supplied hose. Push the connector through the washer from the inside of each butt, then fit and tighten the nut outside to form a seal
